5 Steps to Take If Your Furnace Stops Working

Furnace installation is a specialty service that requires a certain level of expertise. It’s never a good idea to self-install your furnace unless you are a professional. Instead, call a professional installer to do it. You should also let them perform maintenance services rather than doing it yourself. Should your furnace stops working, here are five steps to follow.

1. Remove Dirt from Furnace Filters

Dirty air filters are the main cause of a malfunctioning or inefficient furnace. Furnace air filters may trap dust, debris such as hair, and dirt and restrict airflow. Although your furnace may appear to work okay, an overheated exchanger may restrict the circulation of heat. The solution is to clean the filters regularly. You need to change the filters according to the manufacturer’s recommendations. You can buy a new filter to replace the expired one and simply follow the manufacturer’s manual to install it.

2. Check Whether the Thermostat Is Working

A malfunctioning thermostat can stop your furnace from working. It is the control center of your heat system. To be sure your thermostat is the problem, set it to heat at five degrees over room temperature and check whether the furnace turns on. If not, the problem could be its batteries. As a result, you will see the display go blank as the thermostat’s capacity to operate your heating system is compromised. The best remedy for this problem is to install new batteries, at least once every year. For more info, visit the resources at furnace installation Oshawa.

3. Confirm the Furnace Is On

It is possible the furnace is turned off. If there was furnace repair and maintenance work performed recently, it’s possible the switch was turned off. If the furnace switch on the wall is on, check your fuse or the circuit breaker, which could be turned off. Finally, check the push-in switch below the front panel that covers the blower motor. For your furnace to turn on, this switch must be fully depressed. This basic function may not necessitate the need for an expert.

4. Check the Air Ducts

Problematic air ducts are the reason behind cold spots in your facility, even when the air vents are letting out hot air. Inspect handles protruding from the ducts since they control airflow. Make sure they are fully open. Leaking or poorly designed ducts could be the reason you have cold rooms and might result in higher electricity bills. Check out possible gaps between sections of ducts and loose branching points. With special duct tape, seal the loopholes. Objects in your home, plants, wall art and drapes can also block your vents. Make sure nothing stops the free movement of air in your facility.

5. Call a Furnace Maintenance Professional

If after going through the above steps your furnace is still not working, schedule an appointment with your furnace maintenance expert. Repairing your furnace is not an undertaking you should take lightly. You need a qualified technician to solve the problem. Moreover, you might want to consider regular furnace maintenance checks to flag off and stop current and advancing furnace failures.

You can avoid costly breakdowns through regular equipment maintenance. This not only guarantees peak performance but also prolongs the life of your furnace.

Share This Post